04-19-2014, 12:10 PM
About auto-smooth question.
Auto-smooth command doest subdivide the model. It just create hard edges (the yellow ones) according the angle you specify.
This command apply hard edges globally to a model. You can perform this by selecting some edges and callin Edge|Hardness|Hard.
Create a cube, duplicate it, select one of them, apply auto-smooth and press SHIFT+TAB (quick smooth preview): you will see the difference between them. Note this attribut (hard edges) isnt exported to another softwares, ok?!
https://www.youtube.com/watch?v=bNvli3x4JwA
https://www.youtube.com/watch?v=VbzL95LNrWk
Auto-smooth command doest subdivide the model. It just create hard edges (the yellow ones) according the angle you specify.
This command apply hard edges globally to a model. You can perform this by selecting some edges and callin Edge|Hardness|Hard.
Create a cube, duplicate it, select one of them, apply auto-smooth and press SHIFT+TAB (quick smooth preview): you will see the difference between them. Note this attribut (hard edges) isnt exported to another softwares, ok?!
https://www.youtube.com/watch?v=bNvli3x4JwA
https://www.youtube.com/watch?v=VbzL95LNrWk
__________________________________
www.youtube.com/wings3dchannel
http://www.facebook.com/wings3dchannel
www.youtube.com/wings3dchannel
http://www.facebook.com/wings3dchannel