(06-18-2014, 11:41 PM)ggaliens Wrote: >>>Create a default cube(2x2x2), select a face and inset by 0.0005
Now ... because I'm a big dummy ... when I first tried to recreate ... I hit TAB key and did enter 0.0005 into the numeric box.
Of course this is INSANE because it's a fraction of a percent. I don't think this is what Stem intended at all.
With the model I was building, I was using a scale of 1 unit = 1 meter. I wanted to add insets to the model of 0.5mm, which due to scale, was 0.0005. Those where added with no problem, the problem was when later I attempted to cut across those inset faces.
So, I changed the scale of the model, I instead(after trying various scales) used 1 unit = 1mm and therefore the insets where 0.5. But still, attempting to cut across those inset faces was not allowed, hence my post to "gripe & grumble" about it.
You can check yourself by creating a cube 2000x2000x2000, add a 0.5 inset to a face, then make cut/plane cut across the faces, the cut will not be made across the 0.5 inset faces.