11-07-2014, 07:25 PM
I’m new to Manifoldlab and wings3d for that matter. ManifoldLab is awesome with what you can do with it!
ggaliens, I’ve watched alot of your videos to better understand how to use Manifoldlab. I’m trying to reproduce what you’ve made in this video with the stanford bunny and rod it to make an open foam surface.
https://www.youtube.com/watch?v=fN-jNg3Mbuo
https://www.youtube.com/watch?v=t6HezhFE0qw
I’ve been able to make a nice isotropic surface, subdivide it and removed hard edges and vertices. It looks like the next steps you've done is make the outer foam tidbits (extruded them maybe?) than later the inner foam was made. But how exactly I’m not sure. Could you explain how the process is done? Amazing tool ManifoldLab is!
ggaliens, I’ve watched alot of your videos to better understand how to use Manifoldlab. I’m trying to reproduce what you’ve made in this video with the stanford bunny and rod it to make an open foam surface.
https://www.youtube.com/watch?v=fN-jNg3Mbuo
https://www.youtube.com/watch?v=t6HezhFE0qw
I’ve been able to make a nice isotropic surface, subdivide it and removed hard edges and vertices. It looks like the next steps you've done is make the outer foam tidbits (extruded them maybe?) than later the inner foam was made. But how exactly I’m not sure. Could you explain how the process is done? Amazing tool ManifoldLab is!