Ahh here we go!
Ok those fixes were perfect! I'm glad you had the time to help out as the car looks mighty fine now and that's the best model I have made so far.
Now as I've been working on the helicopter I have run into one small issue, in
the following tutorial: http://en.wikibooks.org/wiki/Wings_3D/Tu..._Propeller
This tutorial requires you to "Select a region of the cylinder, and make a contour with 0 value. Then requires you to hit tab and set Dx to 0". Now my problem is that there is no contour tool and what is dx! The inset tool doesn't seem to do the same job. Just a simple sentence telling me how can I achieve the same result without the tool would be much appreciated!
Once again, thanks for all your help so far!
(01-02-2015, 06:48 PM)micheus Wrote: obs: I didn't take care about your non quads faces - I didn't fix them.Them poor non quads faces, haha. All good.
Ok those fixes were perfect! I'm glad you had the time to help out as the car looks mighty fine now and that's the best model I have made so far.
Now as I've been working on the helicopter I have run into one small issue, in
the following tutorial: http://en.wikibooks.org/wiki/Wings_3D/Tu..._Propeller
This tutorial requires you to "Select a region of the cylinder, and make a contour with 0 value. Then requires you to hit tab and set Dx to 0". Now my problem is that there is no contour tool and what is dx! The inset tool doesn't seem to do the same job. Just a simple sentence telling me how can I achieve the same result without the tool would be much appreciated!
Once again, thanks for all your help so far!