Apologies for such a late reply, but here are the steps that I took to receive the strange extrusion (I honestly have no idea what I'm doing). What steps would I have to apply to reach well, the appropriate stage. What steps must I take to use the inset tool as a replacement for the contour?
On a side note, what I did might make a good spiral staircase of some sort..
https://www.dropbox.com/s/fkvnslwim0vj7n...T.gif?dl=0
Oh and thanks for still helping out!
On a side note, what I did might make a good spiral staircase of some sort..
https://www.dropbox.com/s/fkvnslwim0vj7n...T.gif?dl=0
Oh and thanks for still helping out!