03-10-2015, 03:45 PM
We have tried the replacement part and we made a small error.
The printing was OK, the 3D printer has done what we said it to do.
But, the original part was made of somekind of hard rubber that is still a bit flexible on it's surface.
Not much, but it make a difference when inserting the screw in it.
Our error was to leave to screw at home.
The hole for the screw head is too thight on the printed replica.
We had to use sandpaper...
The printing was OK, the 3D printer has done what we said it to do.
But, the original part was made of somekind of hard rubber that is still a bit flexible on it's surface.
Not much, but it make a difference when inserting the screw in it.
Our error was to leave to screw at home.
The hole for the screw head is too thight on the printed replica.
We had to use sandpaper...
My websites (in french) :
Main • Blog • Shared gallery • 3D Wiki (WIP)
Main • Blog • Shared gallery • 3D Wiki (WIP)