07-28-2015, 05:20 PM
I think you did not understand me properly (partly due to my wording I am sure).
Let me try again.
Imagine you make a complex object, but you have not named stuff as you went. It is not a matter of naming thing like "complex object 1", "complex object 2" but more like "top cover", "wheel-front-left", "wheel-front-right", "axle" and so on. But instead of naming them all one at a time, you should be able to select them all and just RMB > Rename. Which will by default give you a list of all items to rename and you can TAB around the list.
But while you do this you do not see which object you are renaming, and this is not helpful if you got a bunch of objects named cube,cylinder then a number and so on. So the object whose name you are tabbed on could be highlighted with a different highlight colour as I stated above.
The rename menu I mean is the one you get into when you either select from the Geo Graph rename with MMB or if you just select objects and use the normal RMB menu and LMB on rename.
Hope this was a bit clearer.
Let me try again.
Imagine you make a complex object, but you have not named stuff as you went. It is not a matter of naming thing like "complex object 1", "complex object 2" but more like "top cover", "wheel-front-left", "wheel-front-right", "axle" and so on. But instead of naming them all one at a time, you should be able to select them all and just RMB > Rename. Which will by default give you a list of all items to rename and you can TAB around the list.
But while you do this you do not see which object you are renaming, and this is not helpful if you got a bunch of objects named cube,cylinder then a number and so on. So the object whose name you are tabbed on could be highlighted with a different highlight colour as I stated above.
The rename menu I mean is the one you get into when you either select from the Geo Graph rename with MMB or if you just select objects and use the normal RMB menu and LMB on rename.
Hope this was a bit clearer.