Unify edge length

0 Vote(s) - 0 Average

Unify edge length

micheus
Offline

Forum's Admin and Support | Bug fixer

Posts: 3,675
Threads: 183
Joined: Jun 2012

#7

09-20-2015, 04:59 AM

Just in case it can interest I upload the gif I had prepared:

[Image: bracelet_zpsuyvkhy6v.gif]

Start point was the deletion of one segment:
- selected the two edge loop of it boundaries;
- Loop cut command;
- select and Delete the segment.
Next, I selected one face and then:
- [+] increase selection some times;
The whole process is a sequence of:
- Rotate [RMB] - pick the axis and run the adjust;
- [-] decrease selection;
- [CTRL+D] repeat command (Rotate).

at some point I inverted the selection [CTRL+SHIFT+I].

[Image: tw.png]

@MicheusVieira [Image: yt.png]

[Image: yt.png]

@MicheusVieira [Image: da.png]

[Image: da.png]

[Image: ig.png]

micheus4wings3d
* Wings3D Team stands for: Björn and Dan

« Next Oldest | Next Newest »

Users browsing this thread: 1 Guest(s)

Messages In This Thread

Unify edge length - by esha - 09-19-2015, 01:18 PM

RE: Unify edge length - by ggaliens - 09-19-2015, 02:02 PM

RE: Unify edge length - by esha - 09-19-2015, 02:19 PM

RE: Unify edge length - by ggaliens - 09-19-2015, 03:24 PM

RE: Unify edge length - by esha - 09-19-2015, 04:28 PM

RE: Unify edge length - by micheus - 09-19-2015, 06:03 PM

RE: Unify edge length - by micheus - 09-20-2015, 04:59 AM

RE: Unify edge length - by ggaliens - 09-22-2015, 02:36 AM

RE: Unify edge length - by micheus - 09-22-2015, 11:46 AM

RE: Unify edge length - by beng27 - 03-31-2016, 04:05 PM

RE: Unify edge length - by ggaliens - 03-31-2016, 05:18 PM

RE: Unify edge length - by micheus - 03-31-2016, 05:53 PM

RE: Unify edge length - by beng27 - 04-02-2016, 10:31 AM

RE: Unify edge length - by ggaliens - 04-02-2016, 03:25 PM

RE: Unify edge length - by beng27 - 04-22-2016, 05:41 PM

RE: Unify edge length - by ggaliens - 04-22-2016, 07:54 PM