11-16-2012, 01:45 PM
For fabricators and analyst ...
ManifoldLab now has two full-length reports available in body mode and face mode. There will be one for edges also.
What we want to report is all the "extra" properties of Objects (Surface Area, Perimeter, Volume); Faces (Area, Perimeter). For edges ... could probably add dihedral angle and length, but have not done edge report yet.
Ultimately ... if this could MATCH the Tools/Scene-Info dialog and then if that dialog had a "Print to TXT, Print to HTML Button ... that would be nicer than just going right to HTML. Probably.
ManifoldLab now has two full-length reports available in body mode and face mode. There will be one for edges also.
What we want to report is all the "extra" properties of Objects (Surface Area, Perimeter, Volume); Faces (Area, Perimeter). For edges ... could probably add dihedral angle and length, but have not done edge report yet.
Ultimately ... if this could MATCH the Tools/Scene-Info dialog and then if that dialog had a "Print to TXT, Print to HTML Button ... that would be nicer than just going right to HTML. Probably.