Bend: Quick Start tutorial

0 Vote(s) - 0 Average

Bend: Quick Start tutorial

Fonte Boa
Offline

www.youtube.com/wings3dchannel

Posts: 448
Threads: 52
Joined: Nov 2012

#12

12-21-2012, 12:40 PM

A video to show specific workflow, involving Bend Clamped.

In reality this can be produced in less time, but i spent some time at beginning to show the commands i'll repeat in the other steps.

I've selected not just an edge (or vert, etc) to report Wings each requested reference (top, center etc), but complete Edge Loops, so that the operation reference could be keept centered in geometry thickness.

http://www.youtube.com/watch?v=XhVVOXYvc...e=youtu.be

__________________________________
www.youtube.com/wings3dchannel
http://www.facebook.com/wings3dchannel

« Next Oldest | Next Newest »

Users browsing this thread: 1 Guest(s)

Messages In This Thread

Bend: Quick Start tutorial - by Fonte Boa - 12-18-2012, 11:51 PM

RE: Bend: Quick Start tutorial - by PeterC (PC) - 12-19-2012, 12:59 AM

RE: Bend: Quick Start tutorial - by Fonte Boa - 12-19-2012, 01:09 AM

RE: Bend: Quick Start tutorial - by oort - 12-19-2012, 03:35 PM

The joys of Fonte Boa - by maker - 12-20-2012, 08:36 AM

RE: Bend: Quick Start tutorial - by Fonte Boa - 12-20-2012, 08:40 PM

RE: Bend: Quick Start tutorial - by puzzledpaul - 12-20-2012, 11:20 PM

RE: Bend: Quick Start tutorial - by oort - 12-20-2012, 09:31 PM

RE: Bend: Quick Start tutorial - by PeterC (PC) - 12-20-2012, 09:50 PM

RE: Bend: Quick Start tutorial - by Fonte Boa - 12-20-2012, 11:20 PM

RE: Bend: Quick Start tutorial - by Fonte Boa - 12-20-2012, 11:22 PM

RE: Bend: Quick Start tutorial - by maker - 12-22-2012, 03:10 AM

RE: Bend: Quick Start tutorial - by Fonte Boa - 12-21-2012, 12:40 PM

RE: Bend: Quick Start tutorial - by oort - 12-21-2012, 05:51 PM

RE: Bend: Quick Start tutorial - by Fonte Boa - 12-21-2012, 06:37 PM

RE: Bend: Quick Start tutorial - by oort - 12-21-2012, 09:19 PM

RE: Bend: Quick Start tutorial - by GRUMP - 01-22-2022, 01:57 PM

RE: Bend: Quick Start tutorial - by micheus - 01-23-2022, 01:46 PM

RE: Bend: Quick Start tutorial - by GRUMP - 01-24-2022, 10:45 AM