Well ... I'm releasing something that "WORKS". But will need to be tested.
It is done in three PARTS at this time
1) Bevel edges on entire object. No partial bevels place.
2) Run Bevel Retopo (MLAB)
4) Use tighten on all vertices.
This should give you a pretty good result. If it does not ... share a model with me please. And we will try to do better.
It is done in three PARTS at this time
1) Bevel edges on entire object. No partial bevels place.
2) Run Bevel Retopo (MLAB)
4) Use tighten on all vertices.
This should give you a pretty good result. If it does not ... share a model with me please. And we will try to do better.