04-16-2016, 01:29 PM
'Are you sure you cannot eyeball a nice tighten value for you particular model?'
No, it is good. The results it gives are quite acceptable. Just thought that in the case we have equal distances between the edges that form the bevels would be even better (the same applies to the edges amount matter too). It is just a thought.
Also... did discern it after writing my previous message: the bevel retopo does not work for simpler bevel cases. Inset, for example, a face on a cube, extrude the new face created with insetting, select the edges on its base, 'bevel retopo' them... nothing happens. It is something that needs a solution. Someone should have the ability to do a beveling of all the edges of an object at once. It is the natural way of beveling an object. It is the way it works in all the well known modeling apps.
No, it is good. The results it gives are quite acceptable. Just thought that in the case we have equal distances between the edges that form the bevels would be even better (the same applies to the edges amount matter too). It is just a thought.
Also... did discern it after writing my previous message: the bevel retopo does not work for simpler bevel cases. Inset, for example, a face on a cube, extrude the new face created with insetting, select the edges on its base, 'bevel retopo' them... nothing happens. It is something that needs a solution. Someone should have the ability to do a beveling of all the edges of an object at once. It is the natural way of beveling an object. It is the way it works in all the well known modeling apps.