Bridge won't apply to the 2 faces

watercolore · 10-03-2017, 04:45 PM

Hi, I was trying to follow Step 23 of this tutorial:

http://www.wings3d.com/paulthepuzzles/aaBT1s.html

I was following along exactly but it won't apply the bridge. Advice?

micheus · (This post was last modified: 10-03-2017, 07:01 PM by micheus.)

The message seems to be coherent with the image you attached.
I am seeing all the Faces turned to the camera view.
So, to be able to bridge then you need to select faces that are pointing to each other - at least almost. You also can apply this command to each pair of faces - you cannot select the four faces as it seems to be in your image.

Did this help you to find what is wrong?
I'm away from my PC, so I can't illustrate it now.

micheus · (This post was last modified: 10-03-2017, 07:16 PM by micheus.)

Let's try this way...

Looking from the bottom the faces you should make one are these shown bellow:

Now, to help you to understand where is the selection compared to your image notice the coloured table legs only the inner faces for bridge are selected:

In your image both selections are facing the camera view. Wink