02-01-2016, 08:57 PM
Micheus and Fonte Boa explained here how to make a sweep with some number of cuts.
http://www.wings3d.com/forum/showthread.php?tid=1541
Could you implement automatic sweep?
It would connect 2 faces with some number of extruded cuts with the option that faces could be rotated (with a twist).
Similar to handle algorithm in TopMod.
http://www.wings3d.com/forum/showthread.php?tid=1541
Could you implement automatic sweep?
It would connect 2 faces with some number of extruded cuts with the option that faces could be rotated (with a twist).
Similar to handle algorithm in TopMod.