+- Wings 3D Development Forum (http://www.wings3d.com/forum)
+-- Forum: Wings 3D (/forumdisplay.php?fid=1)
+--- Forum: Interface & Usage (/forumdisplay.php?fid=3)
+--- Thread: Holes in Wings3D? (/showthread.php?tid=2929)
Holes in Wings3D? - qewer3322 - 05-09-2020 07:30 PM
So I need to make a hole in the model I am designing. I put a photo below. Need to cut the red part. Is there any way of doing this on Wings3d?
RE: Holes in Wings3D? - micheus - 05-10-2020 01:57 AM
It's kind of a obvious question, but did you tried the Hole command?
RE: Holes in Wings3D? - qewer3322 - 05-10-2020 08:11 AM
Okay, sorry about that. Didnt even know that was a command. Thanks so much!